Philippines Indoor Pickleball Court Lighting: S70 42W Rows in a Shared Badminton Hall

A sports hall in the Philippines rarely stays with one sport. The badminton lines are already painted. The long-bar fixtures already hang from the truss. Then pickleball lines go down on the same floor, because there is room for them, and the ceiling stays exactly where it was.

This page is about that second stage, which is a different job from lighting a new pickleball venue. The row is already installed. The floor underneath it now has to serve two games.

One Layout for a Philippine Hall Running Both Sports

For an indoor pickleball court in a Philippine hall, one Huasport layout option uses the S70 1.16 m 42W long-bar fixture, model WM-S70-1160-DD-42W-108Z. One court takes 24 fixtures, with 12 fixtures on each side, mounted around 5 m and aimed 30 degrees inward toward the playing area. Twelve 1.16 m fixtures form a 13.92 m continuous row per side, and that row is used to cover the 13.4 m main playing-area side length. The planning target is 300-400 lux+ for commercial and recreational play. If the hall also needs competition-level lighting, the design should be reviewed toward 500 lux+ before the final quotation is fixed.

Why the Same Ceiling Can Serve Both Courts

A standard pickleball court measures 44 ft by 20 ft, roughly 13.41 m by 6.10 m. A badminton doubles court measures about 13.4 m by 6.1 m. The two playing rectangles sit almost on top of each other inside the same building envelope, and that is the practical reason so many halls can be re-lined for pickleball without moving a single mounting point.

Aiming is a separate question. A row installed for badminton may already be pointing where pickleball needs it, or it may not. The way to find out is to stand on the new lines and look up, not to re-read the old drawing.

Three Checks After the New Lines Go Down

1. Row Position Against the New Lines

The 13.92 m row runs along the long side of the playing area. After re-marking, check that it still runs parallel to the new long line and still covers it from end to end. If a row overshoots the corner by half a metre, one end of the court ends up weaker than the other, and extra wattage will not repair a row sitting in the wrong place.

2. Aiming Direction at the Bracket

The 30-degree inward tilt is set at the bracket, not at the driver. In normal installation the bracket locks around the 6th hole position to hold that angle. When courts are re-marked, this is the setting worth photographing on both sides, because a row that is aimed correctly on one side and flat on the other is a common finding in mixed-use halls.

3. The View From a Standing Player

Pickleball keeps players close to the net and low for long stretches of a rally, and the ball comes back off a paddle from a compact stance. What the player sees when looking up counts for more than the number on the floor. Five minutes standing at the baseline, then at the net, then along the side line tells a venue owner more than one lux reading taken in the middle of the court.

The Layout in Numbers

Item	Reference Data
Country application	Philippines indoor pickleball court
Hall type	Indoor hall that also runs badminton courts
Fixture model	WM-S70-1160-DD-42W-108Z
Fixture family	Huasport S70 long-bar anti-glare
Body width	11 cm
Power	42W
Fixture length	1.16 m
Quantity per court	24 fixtures
Side layout	12 fixtures on each side
Row structure	Continuous row, no visible gap
Row length per side	13.92 m
Main playing-area reference	13.4 m side length
Mounting reference	Around 5 m
Aiming reference	30-degree inward, bracket 6th hole
Commercial-use target	300-400 lux+ average illuminance
Competition-use reference	500 lux+ average illuminance after final review

What the 42W S70 Adds to a Mixed-Use Floor

S70 and S90 share the same long-bar anti-glare design. The S70 body is 11 cm wide, the S90 body is 13 cm. This plan uses the narrower S70 at 42W, which suits halls where the fixture row has to sit inside an existing ceiling structure.

The front of the fixture is Huasport’s double-layer honeycomb grille. Two grille layers give the light a longer path before it leaves the fixture, and that is what softens the direct view of the LED source when a player looks up. The back uses a thickened aluminum profile rather than a folded iron body, and the bracket fixes into that aluminum section instead of plastic, so the mounting point does not sit on a small plastic insert.

Aiming the Same Way on Every Court

Twenty-four fixtures per court only works when both side rows aim the same way. Set one court at 30 degrees and leave the next one flatter, and players moving between courts feel the difference, even though the fixture counts match.

The adjustable bracket is what makes the setting repeatable. Locking it at the 6th hole gives installers a reference for the 30-degree inward aim, so the second and third court can copy the first one without another discussion at height.

What the Philippine Photos Show

The photo set covers an indoor badminton hall with long-bar rows running over several courts, an indoor pickleball court with chain-link divider fencing between courts, a hall where the row runs along the ceiling with a raised gallery behind the courts, and a close view of the honeycomb grille.

Between them they answer the questions a drawing handles badly. How much structure sits above the row. How far the row sits from the side wall. Whether the fixture body is in view from where players stand.

The photos do not confirm the installed model. That comes from the quotation, the model code and the layout drawing. What the photos do is make the site conversation concrete before the numbers are fixed.

Acceptance Checks for a Hall Doing Both Sports

1. Both sports’ long lines run parallel to the fixture row, not at an angle to it.
2. Each side row carries the same fixture count and the same 30-degree setting.
3. The row length still covers the long side of the playing area end to end.
4. The fixture body is not sitting in the direct line of sight from the baseline or the net area.
5. The average illuminance target is written down for the intended use, with 300-400 lux+ for commercial and recreational play and a 500 lux+ review where competition use is planned.

Those five checks take about an afternoon on site. They are also the details most likely to be argued about later, which is a good reason to write them down before installation starts.

Where This Fits With Other Huasport Court Lighting Pages

For the venue itself, the Huasport pickleball court lighting guide is the core page for court rows, fixture direction and player-comfort checks.

If the hall keeps badminton as its main sport, the Huasport badminton court lighting guide covers the side-row layouts and the aiming reference used on shuttle courts.

Where a glass-wall court is added, treat it as a separate project and start from the Huasport padel court lighting layout, because glass walls and four-side viewing angles change what the fixture row has to do.

For a second view of a Philippine pickleball hall, the earlier note on the S90 42W seamless row layout sits in the same Technical Articles archive. When the court drawings are ready, send them through the Huasport contact page and the layout can be checked against the ceiling structure.

What to Send Before Quotation

A good quote starts with the hall, not the lamp price. Send the number of courts planned for each sport, the ceiling height, the truss or purlin spacing, the new court layout drawing if one exists, and photos taken from the baseline and the side seating area.

Say how the hall will actually be used as well. A venue running evening commercial bookings is working to a different target from one preparing for tournament play, and the fixture count, the aiming and the final illuminance review all follow from that answer.

FAQ

Which Huasport model is used in this Philippines pickleball lighting plan?

The model is WM-S70-1160-DD-42W-108Z, a Huasport S70 1.16 m 42W anti-glare long-bar fixture with an 11 cm body, used for indoor pickleball and badminton court planning.

How many fixtures does one pickleball court use in this layout?

The layout uses 24 fixtures per court, with 12 fixtures on each side of the playing area.

What mounting height and aiming angle are used?

The planning reference is about 5 m mounting height with the fixtures aimed 30 degrees inward, set at the bracket around the 6th hole position.

Can the same fixture row serve badminton and pickleball?

The two playing rectangles are close in size, about 13.4 m by 6.1 m for a badminton doubles court and 44 ft by 20 ft for a pickleball court, so the row length reference is similar. What has to be rechecked is the row position against the new lines, the aiming angle on both sides, and the fixture view from where players stand.

Do the Philippine photos confirm the installed model?

No. The photos show the court environment, the ceiling structure and the fixture row in service. The exact installed model should be confirmed through the quotation, the model code or the layout drawing.